Is there a way to remove macros, or prevent them being copied with the file, in the VBA?

Recommended Steps

1. Ensure All Changes Are Saved

   
   ' After updating properties
   oDoc.Save()
   

2. Force Update of Drawing Views

   
   oDrawingDocument.Update()
   

3. Use Inventor's Built-in DWF Export

   
   oDrawingDocument.SaveAs("C:\Path\To\File.dwf", True)
   

4. Verify Property Source in Title Block
   • Open the title block definition.
   • Check if the field is pulling from <Current Drawing> or <Primary Model>.
   • If it's <Primary Model>, ensure the model file is updated and saved.

If it shows an error with the Arial Narrow font, it may happen because the Inventor can’t access or embed the Arial Narrow during the DWF export. You can try to fix it by reinstalling the font and standardizing the text style in the template.

Yes, you can run an ApprenticeServer-based program on a computer without Inventor installed.

To determine if a part from a content center is a standard part or custom part using, you’ll need to access the ComponentDefinition and use its Is Content Member or IsCustom properties.

To create a tube and pipe run to stop this problem, you should:

• Start with a clean assembly
• Activate the tube and pipe environment properly
• Fully constrain the route sketch
• Use valid tube and pipe styles
• Complete the route before placing components
• Update and validate